Replacing Expansion Cards; Preliminary Steps; Removing An Expansion Card - Fujitsu PRIMERGY CX2550 M1 Upgrade And Maintenance Manual

Expansion cards
6.3.3

Replacing expansion cards

Upgrade and Repair Unit
(URU)
Tools: Phillips PH2 / (+) No. 2 screw driver
Note on network settings recovery
I
When replacing network controllers or the system board, network
configuration settings in the operating system will be lost and replaced
by default values. This applies to all static IP address and LAN teaming
configurations.
Ensure to note down your current network settings before replacing a
controller or the system board.
6.3.3.1

Preliminary steps

Perform the following procedures:
Ê Locate the desired server node with the ID button.
"Shutting down the server node" on page 39
Ê
Ê Remove all external cables from the server node.
"Removing the server node from the server enclosure" on page 40
Ê
"Removing the riser module" on page 41
Ê
6.3.3.2

Removing an expansion card

Ê Remove the defective expansion card as described in
controller from the riser module" on page
Ê If applicable, remove SFP+ transceiver modules from the expansion card,
as described in section
page 103.
Ê If the slot bracket on the defective expansion card is to be reused, remove it
from the board as described in section
brackets" on page
112
"Removing an SFP+ transceiver module" on
95.
Upgrade and Maintenance Manual
Hardware: 5 minutes
"Removing a
111.
"Mounting expansion card slot
CX2550 M1