Siemens VDO DTCO 1381 Technical Description page 261

Events and faults
DTCO 1381 display
Picto. AP Error text
1)
These warning messages will be displayed repetitively every hour until the cause is withdrawn.
2)
These warning messages are not saved in the date memory during calibration mode.
Edition 07/2007
MC Error code Meaning, cause and measures
8000002380 Error during sensor communication.
Possible causes
•
•
Measures
– Check KITAS 2171 sensor cable and correct the following
– Check KITAS 2171.
– Check DTCO 1381 (input B4).
– Use a test device to pair the KITAS 2171 with the DTCO
Replace any defective components.
8000001260 Driving without or without valid driver or workshop card in
card slot 1 or driving with an invalid card combination in
card slot 1 and 2.
Measures
– Check whether a valid driver or workshop card is in card
– Check whether a company card or control card is inserted
4000000200 A tachograph card was inserted after driving had com-
4000000300 menced.
Possible causes
•
Measures
– In general, insert tachograph cards only when the
No steps must be taken.
Technical Description DTCO 1381
13.4 Messages and troubleshooting measures
No data signal (B4)
KITAS 2171 not paired with the DTCO 1381
if necessary:
a) Pin assignment
b) Connection (imperfect contact)
c) Specifications
1381.
slot 1 and insert a valid card if necessary.
in the card slot and eject the card if necessary.
Motion sensor impulses detected before correct reading-
in of a tachograph card
vehicle is motionless.
1)
13 - 29