Printing The Event And Fault Memory - Siemens VDO DTCO 1381 Technical Description

13.3 Printing the event and fault memory

13.3 Printing the event and fault memory

13.3.1 Driver 1 or driver 2 (inserted tachograph card)
Purpose
Step / menu display
1
2
3
4
13 - 8
The event and fault memory can be displayed / printed only when
the vehicle is motionless, and in the case of the ADR variant, only
when the ignition is turned on, see chapter 3.1.3 "Printing or display
of data", page 3-4.
In this menu you can print the saved events and faults of an inserted
tachograph card.
The procedure for driver 2 (tachograph card inserted in card slot 2)
is identical to that for driver 1 (tachograph card inserted in card
slot 1) and will not be described separately below.
Explanation / meaning
Starting from the standard display ...
– press repetitively the button
appears and
– acknowledge with the button
or
– Press the button .
– Select "printout driver 1" with the button
– acknowledge with the button
– Select "driver 1 event" with the button
– acknowledge with the button
The DTCO 1381 starts the selected printout and displays this for
approximately three seconds.
The additional pictograms shown in the calibration mode will not be
printed.
© Siemens VDO Automotive AG
Events and faults
until the display "call main menu"
.
or and
.
or and
.
Edition 07/2007