Instructions For The Regularly Inspection; Legal Requirements For When To Perform A Regularly Inspection - Siemens VDO DTCO 1381 Technical Description

Digital tachograph
Table of Contents

Advertisement

Regularly inspection

11.3 Instructions for the regularly inspection

11.3.1 Legal requirements for when to perform a regularly inspection

Edition 07/2007

11.3 Instructions for the regularly inspection

The DTCO 1381 with its system components is an approved EC
recording equipment in compliance with CR (EEC) 3821/85, annex
I B. If the DTCO 1381 is installed in a vehicle that legally requires
recording equipment, the vehicle will be subject to compulsory
inspections:
CR (EEC) 3821/85, annex I B, paragraph IV (installation inspec-
tions, regularly inspection, and repairs)
For Germany, the compulsory inspections are stipulated in:
§ 57b of StVZO
The device manufacturer or an authorized workshop must perform
these inspections; for new vehicles, these inspections must be per-
formed by approved vehicle manufacturers.
Note the legal provisions applicable in your country and check, how
the regularly inspection must be performed and whether further
tests of the EC recording equipment are prescribed within the regu-
larly inspection.
Attention!
After every intervention into the system, make sure that the
required inspections are performed and corresponding sealing
points are properly resealed.
A regularly inspection must be performed:
After every repair
After every change of the characteristic coefficient (w-value)
After every change of the effective wheel circumference
If the UTC time deviates from the correct time for more than
20 minutes
After every change of the vehicle registration number
At least once within 2 years since the last regularly inspection
Technical Description DTCO 1381
11 - 9

Advertisement

Table of Contents
loading

Table of Contents