Table of Contents
Advertisement
7.3 Performing the preprogramming
7.3.2 Device-specific parameters
7.3.3 Other parameters
7 - 6
Additional device-specific parameters must be preprogrammed for
operation of the DTCO 1381, e.g.:
•
n-constant
•
Configuration
•
CAN configuration
•
Product key
•
Drive shaft I/U
•
Production data (such as dimming parameters, limit values
for n)
•
etc.
The settings for the device-specific parameters are dependent on
the customer or device type.
Other parameters can be preprogrammed if necessary:
•
Installation date
•
Date of the next calibration
•
etc.
© Siemens VDO Automotive AG
Preprogramming
Edition 07/2007
Advertisement
Chapters
Table of Contents
