Siemens VDO DTCO 1381 Technical Description page 197

First calibration
Device-specific parameters
Other parameter
Edition 07/2007
Depending on the variation of the DTCO 1381, other parameters
that are not legally-stipulated must be updated or acknowledged:
• n-constant
• Drive shaft I/U
• etc.
Other parameters can be updated or acknowledged if necessary:
• Installation date
• Date of the next calibration
• etc.
Attention!
Check whether the programmed and saved parameters are
according to the beforehand measured parameters.
Technical Description DTCO 1381
10.5 Performing the first calibration
10 - 19