Table of Contents
Advertisement
9.1 General instructions
9.1.2 Personnel prerequisites
Installation
Activation and calibration
9.1.3 Legal requirements
CR (EEC) 3821/85, annex I B
9 - 4
In the following instructions, the manufacturer assumes that the
personnel possess extensive professional knowledge, securely
master the necessary technical activities, and have been trained in
the use of the DTCO 1381 components as appropriate for the area of
application.
The persons who are charged with the installation of the DTCO 1381
components must complete a training program on the installation
of the DTCO 1381 components.
The persons who are charged with the activation and calibration of
the DTCO 1381 components must:
•
have a valid workshop card.
•
complete a training program on the installation, calibration, and
activation of the DTCO 1381 components.
•
(in Germany) also fulfil the conditions for executing tasks
according to §57b.
When installing the DTCO 1381 please obey the valid legal regula-
tions in your country!
•
New recording units are delivered to installers or vehicle manu-
facturers in a non-activated condition.
•
Before being activated, the DTCO 1381 does not save any data
defined in the CR (EEC) 3821/85, annex I B and will obtain the
full functionality of EC recording equipment only after being
activated.
•
The device must be activated before the vehicle leaves the
location of installation!
•
To perform the activation, a workshop card must be inserted,
the PIN must be entered, and the workshop card must be posi-
tively authenticated.
Note the legal provisions applicable in your country and check when
and how the DTCO 1381 must be activated.
© Siemens VDO Automotive AG
Activation
Edition 07/2007
Advertisement
Chapters
Table of Contents
