Prerequisites For Commissioning - Siemens SINAMICS S120 Installation And Start-Up Manual

Prerequisites for commissioning

Section content
This section describes the commissioning prerequisites:
• CBC10 Communication Board
• STARTER commissioning tool
2.1 Prerequisites for commissioning
Overview
To commission a CAN bus in a SINAMICS S120 drive line-up, the following hardware and
software components are required:
• CBC10 Option Board (CAN Communication Board)
• CompactFlash card with firmware
• Connecting the Control Unit PROFIBUS interface to a PC/PG with PROFIBUS interface
• The STARTER commissioning tool must be installed on your PC/PG
CANopen interface
Commissioning Manual, 12.2004 Edition, 6SL3097-2AA00-0BP1
Note
All the parameters, faults, alarms, and function diagrams for CANopen in the SINAMICS
S120 drive line-up are described in the List Manual SINAMICS S120 /LH1/.
Note
For descriptions of the components in a SINAMICS S120 drive line-up and instructions
on wiring the components, connecting the PROFIBUS interface to a PC/PG, and
installing the STARTER commissioning tool, see the Equipment Manuals /GH1/ and
/GH2/ and the Installation and Start-Up Manual /IH1/.
2
2-1