Volvo C30 2007 Service And Repair Manual page 72

ACCESSORIES AND BODY, CAB Body Frame - Removal, replacement and installation
Rear fender. See FENDER

Seal. See BODY SEAL, SEALING DIAGRAM .
Rust proof. See RUSTPROOFING
Install the side section. See SIDE SECTION, EXPOSING .
REAR SECTION, REAR SHELF
BACK PIECE INNER
NOTE: The illustrations in this service information are used for different model years
and/or models. Some variation may occur. However, the essential information in
the illustrations is always correct.
PREPARATORY WORK
REMOVING COMPONENTS AND ASCERTAINING THE DAMAGE
Remove:
parts according to: REAR SECTION, EXPOSING (2007-2009) or REAR SECTION, EXPOSING

(2010-2012) .
the outer rear section, see TAIL SECTION EXTERNAL

the rear bumper rail. See: REAR BUMPER RAIL.

Determine the extent of the damage. See REAR SECTION
HINT: Save color edges that indicate where the panels are located. This will make aligning easier.
REMOVAL
REMOVING THE INNER REAR SECTION
Drill off the spot welds and the bead welds.
Pry off the inner rear section.
Grind clean.
INSTALLATION
INSTALLING THE INNER REAR SECTION
2012 Volvo C30 T-5