Fig. 165: Identifying Shield And Clips
Courtesy of VOLVO CARS CORPORATION
Install:
the right-hand front wheel
the lower mounting on the nut for the exhaust system. Tighten. See: TIGHTENING TORQUE
the shield under the vehicle using the 7 clips.
Carry out a performance test of the engine coolant heater. See: FUEL-POWERED PREHEATER,
CHECKING .
FUEL FIRED BOOSTER HEATER EXHAUST PIPE (B5254T3, B5254T7)
NOTE:
The illustrations in this service information are used for different model years
and/or models. Some variation may occur. However, the essential information in
the illustrations is always correct.
PREPARATORY WORK
REMOVING COMPONENTS
2012 Volvo C30 T-5
HVAC Climate Units - Removal, Replacement And Installation