Volvo C30 2007 Service And Repair Manual page 485

Fig. 108: Identifying Pipe/Hose Connector
Courtesy of VOLVO CARS CORPORATION
Lower the vehicle.
Remove the upper connector of the charge air hose to the charge air cooler (CAC).
Disconnect the pipe/hose connector to the receiver adjacent to the power steering fluid reservoir. See the
illustration.
Route the pipe/hose down to the compressor under the vehicle.
INSTALLING THE PIPE/HOSE BETWEEN THE COMPRESSOR AND THE RECEIVER
NOTE: For tightening torques, see: TIGHTENING TORQUE .
Place the pipe/hose for the compressor in position by the upper connector to the receiver.
Install:
the pipe coupling, 1 M8. Ensure that the O-rings are securely located between the receiver and the

pipe/hose. Tighten the screw
the upper connector for the charge air pipe
2012 Volvo C30 T-5
HVAC Climate Units - Removal, Replacement And Installation