ACCESSORIES AND BODY, CAB Body Frame - Removal, replacement and installation
Fig. 8: Installing Rear Side Member
Courtesy of VOLVO CARS CORPORATION
Spot-weld the replacement part. Tip diameter: Ø 4.5 mm.
See the illustration for the location of the spot welds.
Apply rustproofing. See RUSTPROOFING .
Install the components, seeREAR SECTION, EXPOSING (2007-2009) or REAR SECTION, EXPOSING
(2010-2012) .
Check the whiplash system in the vehicle, seeCOLLISION PROTECTION UNIT FROM BEHIND FRONT
SEAT CHECK .
SIDE MEMBER, FRONT
Special tools:
see 9997072
NOTE:
The illustrations in this service information are used for different model years
and/or models. Some variation may occur. However, the essential information in
2012 Volvo C30 T-5