Volvo C30 2007 Service And Repair Manual page 562

2012 Volvo C30 T-5
HVAC Climate Units - Removal, Replacement And Installation
Fig. 176: Identifying Overheat Protection Thermostat/Engine Coolant Temperature Sensor
Courtesy of VOLVO CARS CORPORATION
Remove the 1 screw for the holder.
Remove the sensors from the recesses.
Disconnect all the remaining cable terminals and cables apart from:
- those for the overheat protection thermostat at positions 5 and 6 (red cables)
- those for the engine coolant temperature sensor at positions 3 and 4 (blue cables).
The connector is supplied with the replacement part.
INSTALLATION
INSTALLING THE OVERHEAT PROTECTION THERMOSTAT / ENGINE COOLANT TEMPERATURE SENSOR
Install the sensors and position the cable harness along the recesses for the heat exchanger. Ensure that the cable
grommet is correctly located in relation to the fan motor cover.
Install the holders for the sensors using 1 screw. Tighten.