Volvo C30 2007 Service And Repair Manual page 392

Fig. 27: Identifying Screws And Control Module
Courtesy of VOLVO CARS CORPORATION
Disconnect the connector.
HINT: Using a small electrician's screwdriver, pry up the connector at the lock. Pull the connector off.
Remove:
the 4 screws

the control module.

INSTALLATION
INSTALLING THE DAMPER MOTOR MODULE (DMM) FOR RECIRCULATION
Install:
the control module in position. Adjust the shaft journal so that it goes in

the 4 screws. Tighten crosswise

the switch

the glove compartment. See GLOVE COMPARTMENT .

2012 Volvo C30 T-5
HVAC Climate Units - Removal, Replacement And Installation