Volvo C30 2007 Service And Repair Manual page 394

Fig. 28: Identifying Screws And Control Module
Courtesy of VOLVO CARS CORPORATION
Disconnect the connector.
HINT: Using a small electrician's screwdriver, pry up the connector at the lock. Pull the connector off.
Remove:
the 3 screws

the control module.

INSTALLATION
INSTALLING THE DAMPER MOTOR MODULE (DMM) FOR THE DEFROSTER
Install:
the control module in position. Adjust the shaft journal so that it goes in

the 3 screws. Tighten crosswise

the switch

the dashboard. See: DASHBOARD

2012 Volvo C30 T-5
HVAC Climate Units - Removal, Replacement And Installation