Volvo C30 2007 Service And Repair Manual page 633

2012 Volvo C30 T-5
TRANSMISSION Clutch - Removal, replacement and installation
Install the screws for the rear mounting of the sub-frame. Loosely install new M16 screws, together with the
brackets and their 4 M8 screws.
Tighten the M16 screws. See TIGHTENING TORQUE .
Tighten the 4 M8 screws for the brackets. Tighten.
Install the rubber mountings for the exhaust pipe mounting.
INSTALLING THE SCREWS, CONTINUED
Fig. 41: Identifying Screws For Steering Gear/Sub-Frame
Courtesy of VOLVO CARS CORPORATION
Tighten the front M12 screws to the subframe. See TIGHTENING TORQUE .
Install new screws for the steering gear and sub-frame loosely.
Tightening is performed later from the engine compartment.
FINISHING
INSTALLING THE BEVEL GEAR
Install the bevel gear. See BEVEL GEAR .
INSTALLING THE LEFT DRIVE SHAFT
Install the left-hand drive shaft. See DRIVESHAFT LEFT .
CHECKING THE TRANSMISSION FLUID LEVEL
Top up the transmission with fluid if necessary. See TRANSAXLE OIL .