Volvo C30 2007 Service And Repair Manual page 389

Remove:
the 3 screws

the control module.

INSTALLATION
INSTALLING THE DAMPER MOTOR MODULE (DMM) FOR TEMPERATURE
Install:
the control module in position. Adjust the shaft journal so that it goes in

the 3 screws. Tighten crosswise

the switch

the dashboard. See: DASHBOARD

NOTE: Identify the damper motor module (DMM) temperature. See VIDA (Volvo scan
tool) Vehicle communication.
FINISHING
TESTING THE CLIMATE CONTROL SYSTEM
Carry out a performance test on the climate control unit. See: CLIMATE CONTROL SYSTEM, CHECK .
ACTUATOR, MIXER DAMPER
NOTE: The illustrations in this service information are used for different model years
and/or models. Some variation may occur. However, the essential information in
the illustrations is always correct.
PREPARATORY WORK
IMPORTANT INFORMATION
The damper motor module (DMM) for air distribution is only on the left-hand side.
REMOVING THE DASHBOARD
Remove the dashboard. See: DASHBOARD
REMOVAL
REMOVING THE DAMPER MOTOR MODULE (DMM) FOR AIR DISTRIBUTION
2012 Volvo C30 T-5
HVAC Climate Units - Removal, Replacement And Installation