Items Related To The Mechanical Specifications - Roland monoFab SRM-20 User Manual

Tool-Diameter Offset Value
[Setup]
On the VPanel, click
coordinate system .
Tool-Diameter Offset Type (G41, G42)
Select type A or type B . On the VPanel, click
Optional Block Skip (/)
Enable or disable the optional block skip feature . On the VPanel, click

Items Related to the Mechanical Specifications

This section describes the NC codes that are dependent on the machine's mechanical specifications .
"Separate volume "NC Code Reference Manual"
Dimension Word
Of the four dimension words - X, Y, Z, and A - only X, Y, and Z are supported .
Data Settings (G10)
The ranges of the G10 parameters are as follows .
Parameter : Number
Function : Compensation number
Acceptable range : 1 to 8
Valid range : 1 to 8
Parameter : Radius
Function : Tool-diameter offset value
Acceptable range : Range 1
Valid range : 0 to 10 mm (0 to 0 .3937 inches)
[NC Code setting] . Then set this value on the
and then
[Setup]
and then
[Tool-diameter Offset]
[NC Code setting] . Then set this value on the
[Operation Settings] and then
112
tab . You can also use NC programs to set the G10
[NC Code]
tab .
[NC Code setting] . Then set this value on the
NC Code Specifications
[NC Code] tab .