2-Setup Tasks. Cutting The Base And Workpiece; Preparation Of The Base - Roland MDX-40A Step-By-Step Manual

Preparation of the base

1
Prepare the base workpiece to attach to the table.
This is a sacrificial base.
Ensure the base workpiece is bigger than the
model workpiece. Clean the MDX40A table to
remove any dust or swarf.
2RTT
2
Apply just enough double sided tape
to the base Too much and you wont
get it off. Ensure the tape is flat, free
of swarf and does not wrinkle or
overlap other pieces.
3
Fix the base material to the table. Ensure it is
stuck firmly.
Step 3.+Setup Tasks. Cutting the Base and workpiece
.3UTT
Base
Table
.3UTT
14