Oam Cable Assemblies - Nortel Optical Multiservice Edge 6130 Planning Manual

8-16 Ordering information and system engineering rules

OAM cable assemblies

Table 8-17
cables are used to provide synchronization, alarm, user interface and network
element connectivity. Refer to
instructions.
Table 8-17
DCN and craft access cables
Description
F1 cable
Modem Cable
Ethernet cable RJ-45 to RJ-45 crossover (1.5 m)
Ethernet cable RJ-45 to RJ-45 crossover (5 m)
Ethernet cable RJ-45 to RJ-45 crossover (10m)
Ethernet cable RJ-45 to RJ-45 crossover (20 m)
Ethernet cable RJ-45 to RJ-45 crossover (25 m)
Ethernet cable RJ-45 to RJ-45 crossover (40 m)
Ethernet cable RJ-45 to RJ-45 straight (10m)
Ethernet cable RJ-45 to RJ-45 straight (20 m)
Ethernet cable RJ-45 to RJ-45 straight (25 m)
Ethernet cable RJ-45 to RJ-45 straight (40 m)
Ethernet cable RJ-45 to RJ-45 straight (60 m)
Note 1: This F1 interface cable connects to the serial port on the OAM circuit pack and supports an
asynchronous interface.
Note 2: This modem cable has the DSR pin isolated.
Note 3: This cable provides an Ethernet connection between the Craft port on the OAM circuit pack to a
PC directly connected.
Note 4: This cable provides an Ethernet connection between the LAN port on the OAM circuit pack to the
DCN network.
Optical Multiservice Edge 6130 NT6Q92MA Rel 1.0 Iss 1 Standard September 2006
through Table 8-19
Note: The LAN and Craft ports on the OAM circuit pack are wired as
MDI. Use crossover cables to connect the LAN and Craft ports to other
MDI ports (such as those on workstations). Use straight-through cables to
connect the LAN and Craft ports to MDI-X ports (such as those on
switches).
list the available OAM cable assemblies. These
Procedure 8-2 on page 8-29
Order code
NT6Q71AF
NT6Q71AG
NTUC58PW
NTUC58PL
NTUC58PM
NTUC58PP
NTUC58PQ
NTUC58PN
NTUC58PS
NTUC58PU
NTUC58PV
NTUC58PR
NTUC58PT
for ordering
Notes
1
2
3
3
3
3
3
3
4
4
4
4
4