Oam Comms Management; Oam Comms Routing - Nortel Optical Multiservice Edge 6130 Planning Manual

6-26 OAM&P description
The DCC transparency can be configured from the Overhead Tunnel
application available from the Configuration main menu item in the local
craft access terminal. For more details on how to provision the DCC interfaces,
refer to Provisioning and Protection Switching Procedures, 323-1855-310.

OAM comms management

The OME6130 uses an IP-based comms infrastructure for network element
management and interworking with IP-based DCC network elements.
However, OME6130 also supports OSI-based DCC for interworking with
OSI-based network elements.
For more information about provisioning the communication parameters, see
Provisioning and Protection Switching Procedures, 323-1855-310.

OAM comms routing

Support of IP-based and OSI-based DCC requires support of several routing
protocols. OME6130 supports the following routing protocols:
•
•
Optical Multiservice Edge 6130
Integrated ISIS (iISIS)
iISIS can be used as the internal DCN routing protocol and is available on
all DCC interfaces. iISIS is not available on the LAN, Craft and RS232
ports.
The iISIS settings for the OME6130 NE can be provisioned using the iISIS
application available from the Configuration/DCN menu item in the local
craft access terminal. The iISIS settings for the embedded channel
interfaces can be configured using the Network interface application also
available from the Configuration/DCN menu. For more details on how to
provision iISIS, refer to Provisioning and Protection Switching
Procedures, 323-1855-310. For more information on DCN planning, refer
to Appendix A: Data communications planning on page
OSPF
The OSPF feature enables monitoring neighboring network elements and
retrieving routing information for In Band Communication (IBC). The
OSPF feature can be enabled or disabled for the embedded communication
channel interfaces or for the LAN access to the public DCN.
The OSPF area can be provisioned using the OSPF application available
from the Configuration/DCN menu item in the local craft access terminal.
The OSPF settings for the embedded channel interface or the LAN port can
be configured using the Network interface application also available from
the Configuration/DCN menu. For more details on how to provision
OSPF, refer to Provisioning and Protection Switching Procedures,
323-1855-310. For more information on DCN planning, refer to
A: Data communications planning on page
NT6Q92MA Rel 1.0 Iss 1 Standard September 2006
10-1.
Appendix
10-1.