8X10/100Bt L1 Circuit Pack - Nortel Optical Multiservice Edge 6130 Planning Manual

8x10/100BT L1 circuit pack

The 8x10/100BT L1 circuit pack can be installed in the tributary slots on the
OME6130 chassis to offer 10/100BT Ethernet services.
faceplate of a 8x10/100BT L1 circuit pack.
The PEC for the 8x10/100BT L1 circuit pack is listed in
Table 4-7
8x10/100BT L1 circuit pack
8x10/100BT L1 circuit pack
8x10/100BT L1
Figure 4-8
8x10/100BT L1 circuit pack
8x10/100BT L1 functionality overview
The 8x10/100BT L1 circuit pack consists of two entities (client facing and line
facing):
•
•
The 8x10/100BT L1 circuit pack supports the following:
•
•
•
•
•
•
client facing interfaces referred to as 10/100BT Ethernet ports
line facing (mapped for transport via SDH containers) interfaces referred
to as WAN ports
supports the transport of up to eight (8) 10/100BT services ports
mapping of 10/100BT Ethernet to/from SDH containers via Framed GFP
at following levels:
— VC12 and VC3 operating granularity
— virtual concatenation (VC12-nv, where n=1 to 63 and VC3-nv, where
n = 1 to 3)
the total bandwidth available for connections on the 8x10/100BT L1
circuit pack is STM-1 (155 Mb/s). The bandwidth is shared between the 8
10/100BT ports of the circuit pack
The maximum bandwidth is 10 Mb/s for the 10BT ports and 100 Mb/s for
the 100BT ports
supports provisionable Ethernet link integrity (Enabled or Disabled)
supports provisionable Ethernet auto-negotiation (Enable or Disable) with
the local Ethernet link partner as per clause 37 of IEEE 802.3-2000
Planning Guide NT6Q92MA Rel 1.0 Iss 1 Standard September 2006
Hardware description 4-11
PEC code
NT6Q13AB
Figure 4-8 shows the
Table 4-7.