Nortel Optical Multiservice Edge 6130 Planning Manual page 192

10-6 Appendix A: Data communications planning
Table 10-3
Network interface provisionable parameters summary
Network Admin
interface Status
AGRE <Up>
(see Note 4)
SGRE-1 <Up/Down> • Layer2 Protocol=GRE
(see Note 5)
Note 1: It is recommended to leave the Eth0 network interface port in Admin Up state.
Note 2: OSPF and iISIS cannot be simultaneously enabled for a network interface.
Note 3: E1/VC12 management communication between OME6130 and OME6110 (Release 1, Release
2.0, Release 2.01 software) should use Layer 2 Protocol as Standard PPP, RFC1661.
Note 4: The Auto GRE tunnel is automatically created when iISIS is enabled at the nodal level on the
NE. The AGRE network interface parameters are not user-provisionable.
Note 5: The Static GRE tunnel can only be created if iISIS is enabled at the nodal level.
Table 10-4
Dynamic routing protocol parameters
Routing Status
Protocol
OSPF <Enable /
Disable>
iISIS <Enable /
Disable>
(see Note 1)
Note 1: In this release, the L2 Default Metric and L2 Routing Only parameters are not
supported for iISIS routing protocol.
For more information on the detail procedures, refer to Provisioning and
Protection Switching Procedures, 323-1855-310.
Optical Multiservice Edge 6130
Layer 2 parameters
• Layer2 Protocol=GRE
• Remote MAA=<490000>
• Remote SID=<000000000000>
• NSAP Selector Byte=<2F>
Provisionable parameters
• Hello Interval=<10>
• Router Dead Interval=<40>
• OSPF Authentication Mode=
<Disable authentication /
Simple password>
• Password/Key=<>
• L1 Default Metric=<4>
• L2 Default Metric =<4>
• L2 Routing Only=<Disable /
Enable>
NT6Q92MA Rel 1.0 Iss 1 Standard September 2006
Layer 3 OSPF
parameters support
• Layer3 No
Protocol=IP
• MTU=446 bytes
• Layer3 Yes
Protocol=IP
• MTU=<446> bytes
Network Interface
support
• eth0
• mgmt1, mgmt2
• ecc_x_x
• SGRE-x
• ecc_x_x
iISIS
support
No
No