Refer To Optical Specifications; For Specifications Of The Sfps And For More Details On - Nortel Optical Multiservice Edge 6130 Planning Manual

4-14 Hardware description
•
•
•
•
•
•
•
•
•
Refer to
Refer to
the associated PEC and the sections in
more details on functionality supported.
Optical Multiservice Edge 6130
the total bandwidth available for connections on the 2xGE L1 circuit pack
is 4 x STM-1 (622 Mb/s). The bandwidth is shared between the two GE
ports of the circuit pack
supports provisionable Ethernet link integrity (Enabled or Disabled)
supports provisionable Ethernet auto-negotiation (Enable or Disable) with
the local Ethernet link partner as per clause 37 of IEEE 802.3-2000
supports full duplex mode
64 byte to 9600 byte Ethernet frame support
supports provisionable Ethernet maximum transfer unit (MTU) between
64 and 9600 (default) bytes
supports Ethernet flow control capabilities
— None (advertises flow control not supported)
— Both (advertises asymmetric or symmetric flow control toward the
local device)
— Asymmetric (default) (advertises asymmetric flow control toward the
link partner)
— Symmetric (advertises symmetric flow control toward the link partner)
Note: This attribute is ignored when auto-negotiation is disabled.
supports provisionable Link Capacity Adjustment Scheme (LCAS)
(Enabled or Disabled) as per G.7402/Y.1305
Ethernet and WAN PMs
Note: Gigabit Ethernet services map to SDH containers and are assigned
as WAN associations to the STM-1/4 interfaces. They can therefore use the
traffic protection schemes supported by the STM-1/4 interfaces to provide
a protected Gigabit Ethernet service without the requirement of a
redundant handoff from the subtending Gigabit Ethernet equipment.
Optical specifications on page 7-23
Ordering information and system engineering rules on page 8-1
NT6Q92MA Rel 1.0 Iss 1 Standard September 2006
for specifications of the SFPs.
OAM&P description on page 6-1
for
for