Ordering Cables, Documentation, And Services - Nortel Optical Multiservice Edge 6130 Planning Manual

Procedure 8-2

Ordering cables, documentation, and services

Use this procedure to order cables, documentation, and services for the
OME6130 equipment ordered in
procedure for each site in the OME6130 network.
Before you start
• Complete a network design, including a DCN and a synchronization plan.
• Read OME6130 network element configuration rules on page
• Photocopy Table 8-27 on page 8-32
Procedure tasks
• Record site specific information
• Order power cables
• Order optical fiber patch cords
• Order OAM and LAN cables (DCN, user interface, alarm and synchronization)
• Order documentation
• Order services
Expected results
• You have a complete list of cables, documentation, and services for an OME6130 site.
• If the expected results do not occur:
— Review the network design and repeat the procedure.
— Contact your next level of support.
Action
Step
1
2
and
(step 1).
(step 2).
(step 3).
(step 10).
(step 11).
Action
Note: Use a photocopy of
references in this procedure refer to this table unless otherwise noted.
Record site specific information on
page 8-32.
Order DC power cables for the number of OME6130 NEs specified in
Order the appropriate DC cable for the region, as specified in
the length required, as shown on
Note: Refer to Table 8-20 on page 8-18
for orderable codes and application rules.
Planning Guide NT6Q92MA Standard Rel 1.0 Iss 1 September 2006
Ordering information and system engineering rules 8-29
Procedure 8-1 on page
8-2.
Table 8-28 on page 8-33
Table 8-27 on page 8-32
Line 1
Line 3.
and
8-22. Repeat this
(if required).
(step 4).
for this procedure. Line
through Line 8 of Table 8-27 on
Line
Bay equipping rules on page 8-4
Line 2.
1, and for