Nortel Optical Multiservice Edge 6130 Planning Manual page 168

8-26 Ordering information and system engineering rules
Procedure 8-1 (continued)
Ordering OME6130 chassis, circuit packs, and software
Step
23
24
25
26
27
28
Optical Multiservice Edge 6130 NT6Q92MA Rel 1.0 Iss 1 Standard September 2006
Action
Order one (1) NT6Q70AE, Filler Panel for aggregate slot 7.
Order the small form-factor pluggable (SFP) modules.
Note: Refer to Table 8-8 on page 8-10
for orderable part numbers and application rules for the small form-factor
pluggable modules.
Order the 75 ohm termination panel:
If Line 13 is Then
75 ohm Order the number of NT6Q71EA, 75 ohm BNC
termination panel as specified on
step
120 ohm Go to
100 ohm Go to
none Go to
Order the E1 cables for the 75 ohm termination panel for the 28xE1/DS1
circuit pack:
If Line 15 is Then order the number obtained at
1 one (1) NT6Q75AA (Right routing - 1 meter cable)
5 one (1) NT6Q75CA (Right routing - 5 meter cable)
Go to step 29.
Order the E1 cables for the 120 ohm application for the 28xE1/DS1 circuit
pack:
If Line 15 is Then order the number obtained at
5 one (1) NT6Q73BA (Right routing - 5 meter cable)
10 one (1) NT6Q73CA (Right routing - 10 meter cable)
15 one (1) NT6Q73DA (Right routing - 15 meter cable)
20 one (1) NT6Q73EA (Right routing - 20 meter cable)
Go to step 29.
Order the DS1 cables for the 28xE1/DS1 circuit pack:
If Line 15 is Then order the number obtained at
15 one (1) NT6Q73QA (Right routing - 15 meter cable)
30 one (1) NT6Q73TA (Right routing - 30 meter cable)
and Shelf equipping rules on page 8-4
26.
step 27
step 28
step 29
Line 14. Go to
step 13 times of
step 13 times of
step 13 times of