Nortel Optical Multiservice Edge 6130 Planning Manual page 124

7-22 Technical specifications
Table 7-21 (continued)
Connector specifications for right routing E1/DS1 cables
Feature
Hood
Hood exit
Depth
Component
Terminations
Figure 7-4
E1 coaxial cable bundle specification
Optical Multiservice Edge 6130
Physical specification
• Angled exit recommended at 100 degrees.Close proximity of connector
positions on OME6110 faceplate prevents the user of many low profile
right angle exit hoods. (See
60 mm maximum connector hood and cable depth from connector mating
face
Metal plated plastic (100% coverage) or fully metal shielded connector
hood
Shielded hood terminated to cable shield and to both hood mounting
screws via the cable drain wires (both mounting screws must attach to
the drain wire through Y'd arrangement, or two drain wires) and
interference contact to exposed braid at the exit of the cable from hood.
NT6Q92MA Rel 1.0 Iss 1 Standard September 2006
Figure 7-5 on page 7-23)