Nortel Optical Multiservice Edge 6130 Planning Manual page 213

DCN example 1 - Using static routing with direct LAN connections to
OME6130 network elements.
In this example (see
10-29), each OME6130 is directly connected to external DCN via the LAN
ports.
Routing protocol (static or dynamic) is not required from the DCN router to
each of the OME6130 network element. The external router and the OME6130
LAN interfaces are in the same subnet. A static route is required from each of
the network element to the DCN router interface.
No DCC is used in between the network elements.
This example does not provide redundant access to any of the OME6130
network elements because each OME6130 NE is connected to the external
DCN with one Ethernet port (i.e. LAN port).
DCN provisioning details
Table 10-5 on page 10-29
parameters for the DCN example 1 configuration.
Note: For parameters not listed, use the default settings.
Planning Guide NT6Q92MA Rel 1.0 Iss 1 Standard September 2006
Appendix A: Data communications planning 10-27
Figure 10-3 on page 10-28
and Table 10-6 on page 10-30
and Figure 10-4 on page
detail the DCN