E1/Ds1 Cable Assemblies; E3/Ds3 Cable Assemblies - Nortel Optical Multiservice Edge 6130 Planning Manual

8-12 Ordering information and system engineering rules

E1/DS1 cable assemblies

Table 8-10
respectively. These cables are used to provide E1 (input and output)
connectivity for 120 ohm applications, where no termination panel is required
and DS1 connectivity for 100 ohm applications.
Table 8-10
E1 cable assemblies
Description
120Ohm Telco 5M Cable - Right Routing
120Ohm Telco 10M Cable - Right Routing
120Ohm Telco 15M Cable - Right Routing
120Ohm Telco 20M Cable - Right Routing
Note 1: This cable provides 64-pin balanced 120 ohm for the E1 services on the 28xE1/DS1 circuit
pack.
Note 2: This cable has a shielded connector to connect to the 28xE1/DS1 circuit pack.
.
Table 8-11
DS1 cable assemblies
Description
100Ohm Telco 15M Cable - Right Routing
100Ohm Telco 30M Cable - Right Routing
Note 1: This cable provides 64-pin balanced 100 ohm for the DS1 services on the 28xE1/DS1 circuit
pack.
Note 2: This cable has a shielded connector to connect to the 28xE1/DS1 circuit pack.

E3/DS3 cable assemblies

Table 8-12
pack. These cables are used to provide E3/DS3 (input and output) connectivity
to the OME6130 network element.
Table 8-12

E3/DS3 cable assemblies

Description
BNC Connector (735A)
DS3 735A Coaxial Cable - 10M BNC
Optical Multiservice Edge 6130 NT6Q92MA Rel 1.0 Iss 1 Standard September 2006
and Table 8-11
Note: Refer to E1/DS1 cable pinouts and assemblies on page 7-18
cable requirements if the cables are to be sourced locally.
lists the available E3/DS3 coaxial cables for the 3xE3/DS3 circuit
lists the available E1/DS1 interface cables
Order code
NT6Q73BA
NT6Q73CA
NT6Q73DA
NT6Q73EA
Order code
NT6Q73QA
NT6Q73TA
Order code
A0609866
NT7E43BB
for the
Notes
1, 2
1, 2
1, 2
1, 2
Notes
1, 2
1, 2
Notes
1
2, 3