Toyota Camry Manual page 1369

DI–342
2 Connect the OBDII scan tool or TOYOTA hand–held tester and read value for
voltage output of A/F sensors (bank1, 2 sensor1).
PREPARATION:
(a) Connect the OBD II scan tool or TOYOTA hand–held tester to the DLC3.
(b) Warm up the A/F sensors (bank1, 2 sensor1) with the engine at 2,500 rpm for approx. 90 sec.
CHECK:
Read voltage of A/F sensors (bank 1, 2 sensor 1) on the screen of OBD II scan tool or TOYOTA hand–held
tester when you perform all the following conditions.
HINT:
The voltage of AFRX and AFLX terminals of ECM is fixed at 3.3 V and the voltage of AFRu and AFLu
terminals is fixed at 3.0 V. Therefore, it is impossible to check the A/F sensors (bank1, 2 sensor1) output
voltage at the terminals (AFRX, AFLX/AFRu, AFLu) of ECM.
OK:
Condition
Engine idling
Engine racing
Driving at engine speed 1,500 rpm or more and vehicle
speed 40 km/h (25 mph) or more, and operate throttle
valve open and close.
HINT:
D
During fuel enrichment, there is a case that the output voltage of A/F sensors (bank1, 2 sensor1) is
below 2.8 V (* 0.56 V), it is normal.
D
During fuel cut, there is a case that the output voltage of A/F sensors (bank1, 2 sensor1) is above 3.8
V (* 0.76 V), it is normal.
D
If output voltage of A/F sensors (bank1, 2 sensor1) remains at 3.30 V (* 0.660 V) even after performing
all the above conditions, A/F sensors (bank1, 2 sensor1) circuit may be open.
D
If output voltage of A/F sensors (bank1, 2 sensor1) remains at 3.8 V (* 0.76V) or more, or 2.8 V (*0.56
V) or less even after performing all the above conditions, A/F sensors (bank1, 2 sensor1) circuit may
be short.
*: When you use the OBD II scan tool (excluding TOYOTA hand–held tester).
NG
DIAGNOSTICS – ENGINE (1MZ–FE)
D Not remains at 3.30 V (*0.660 V)
D Not remains at 3.8 V (*0.76 V) or more D Not remains at 3 8 V (*0 76 V) or more
D Not remains at 2.8 V (*0.56 V) or less
*: When you use the OBD II scan tool (excluding TOYOTA hand–held tester)
OK Go to step 9.
A/F Sensor Voltage value
Author : Date :
577