Toyota Camry Manual page 1362

3 Check voltage between terminal SPD of ECM connector and body ground.
ON
OK
4 Check for open in harness and connector between junction connector (J14) and
combination meter (See page IN–31).
OK
Check and replace ECM (See page IN–31).
DIAGNOSTICS –
PREPARATION:
(a) Turn the ignition switch ON.
(b) Disconnect the E8 connector of ECM.
CHECK:
Measure voltage between terminal SPD of the ECM connector
and body ground.
E8 OK:
Voltage: 9 ∼ 14 V
SPD (+)
A02029
NG
NG
ENGINE (1MZ–FE)
Check for open in harness and connector
between junction connector (J15) and ECM
(See page IN–31).
Repair or replace harness or connector.
Author :
DI–335
Date :
570