Toyota Camry Manual page 1423

DI–396
P
R
N
DIAGNOSTICS
(f)
If the indicator is not aligned with the correct position, carry out
the following adjustment procedures.
Q00199
Q01561
(g)
Neutral Basic line
If it is not as stated above, carry out the following adjustment
procedures.
Groove
AT4478
(h)
– AUTOMATIC TRANSAXLE (A140E)
Inspect and adjust the shift lever position.
When shifting the shift lever from the N position to other
positions, check that the lever can be shifted smoothly
and accurately to each position and that the position indi-
cator is aligned with the correct position.
(1) Loosen the nut on the shift lever.
(2) Push the control shaft fully rearward.
(3) Return the control shaft lever 2 notches to N posi-
tion.
(4) Set the shift lever to N position.
(5) While holding the shift lever lightly toward the R
position side, tighten the shift lever nut.
Torque: 13 N·m (130 kgf·cm, 9 ft·lbf)
(6) Start the engine and make sure that the vehicle
moves forward when shifting the lever from the N to
D position and reverses when shifting it to the R
position.
Inspect and adjust the park/neutral position.
Check that the engine can be started with the shift lever
only in the N or P position, but not in other positions.
(1) Loosen the park/neutral position switch bolt and set
the shift lever to the N position.
(2) Align the groove and neutral basic line.
(3) Hold the switch in position and tighten the bolt.
Torque: 5.4 N·m (55 kgf·cm, 48 in·lbf)
For continuity inspection of the park/neutral position
switch, see page DI–424.
Check the idle speed.
Idle speed : 750 ± 50 rpm
(In N position and air conditioner OFF)
Author : Date :
631