Toyota Camry Manual page 1460

3 Check OVRDRIVE CUT SW2 signal.
ON
w/ Engine Immobiliser System
(+)
(–)
w/o Engine Immobiliser System
BE3840
Q07661
Q07754
NG
DIAGNOSTICS
When using TOYOTA hand–held tester:
PREPARATION:
(a)
(b)
(c)
CHECK:
Read the OVRDRIVE CUT SW2 signal on the TOYOTA hand–
held tester.
OK:
When not using TOYOTA hand–held tester:
PREPARATION:
Turn the ignition switch ON.
CHECK:
Check voltage between terminal OD2 of ECM and body ground.
OK:
OD2
OD2
D01716
OK
– AUTOMATIC TRANSAXLE (A140E)
Remove the DLC3 cover.
Connect TOYOTA hand–held tester to the DLC3.
Turn the ignition switch ON and TOYOTA hand–held tes-
ter main switch ON.
O/D main switch condition
O/D ON (Pushed in)
O/D OFF (Pushed once again)
O/D main switch condition
O/D ON (Pushed in)
O/D OFF (Pushed once again)
Check and replace the ECM
(See page IN–31).
Author :
DI–433
OVRDRIVE CUT SW2 signal
OFF
ON
Voltage
9 ∼ 14
Below 1.5 V
Date :
668