DI–320
2
Check vacuum hoses (1), (4), (5), (6), (7) and (8) on page DI–311).
CHECK:
(a)
Check that the vacuum hose is connected correctly.
(b)
Check the vacuum hose for looseness and disconnection.
(c)
Check the vacuum hose for cracks, hole, damage and blockage.
OK
3
Check voltage between terminals VC and E2 of ECM connector
(See page DI–311, step 9).
OK
4
Check voltage between terminals PTNK and E2 of ECM connectors
(See page DI–311, step 10).
NG
5
Check for open and short in harness and connector between vapor pressure
sensor and ECM (See page IN–31).
OK
Replace vapor pressure sensor.
DIAGNOSTICS
–
ENGINE (1MZ–FE)
NG
Repair or replace.
NG
Check and replace ECM (See page IN–31).
OK
Go to step 6.
NG
Repair or replace harness or connector.
Author :
Date :
555