Toyota Camry Manual page 1484

INSPECTION PROCEDURE
1 Check operation of speedometer.
CHECK:
Drive the vehicle and check if the operation of the speedometer in the combination meter is normal.
HINT:
The vehicle speed sensor is operating normally if the speedometer display is normal.
OK
2 Check for short in harness and connector between terminal SPD of ECM and
body ground.
Except California, w/ Engine Immobilizer
and / or TRAC:
California, w/ Engine Immobilizer
and / or TRAC:
P23875
A02373
OK
DIAGNOSTICS
SPD
SPD
A02155
– AUTOMATIC TRANSAXLE (A541E)
NG Check speedometer circuit.
PREPARATION:
(a) Remove the glove compartment (See page SF–73).
(b) Disconnect the connector from ECM.
CHECK:
Check continuity between terminal SPD of ECM and body
ground.
OK:
No continuity (1 M Ω or higher)
NG Repair or replace harness or connector.
Author :
DI–457
Date :
692