Toyota Camry Manual page 1033

DI–6
DIAGNOSTICS – ENGINE (5S–FE)
(2) Connect the OBD II scan tool or TOYOTA hand–
held tester to DLC3 under the instrument panel low-
er pad.
(3) Turn the ignition switch ON and turn the OBD II scan
tool or TOYOTA hand–held tester switch ON.
(4) Use the OBD II scan tool or TOYOTA hand–held
tester to check the DTCs and freezed frame data
and note them down. (For operating instructions,
see the OBD II scan tool's instruction book.)
(5) See page
NOTICE:
D
When simulating symptoms with an OBD II scan tool
(excluding TOYOTA hand–held tester) to check the
DTCs, use normal mode. For code on the DTC chart
subject to "2 trip detection logic", perform the follow-
ing either action.
D
Turn the ignition switch OFF after the symptom is
simulated the first time. Then repeat the simulation
process again. When the problem has been simulated
twice, the MIL lights up and the DTCs are recorded in
the ECM.
D
Check the 1st trip DTC using Mode 7 (Continuous Test
Results) for SAE J1979.
(c) Clear the DTC.
The DTCs and freezed frame data will be erased by either
action.
(1) Operating the OBD II scan tool (complying with SAE
J1978) or TOYOTA hand–held tester to erase the
codes. (See the OBD II scan tool's instruction book
for operating instructions.)
(2) Disconnecting the battery terminals or EFI fuse.
NOTICE:
If the TOYOTA hand–held tester switches the ECM from
normal mode to check mode or vice–versa, or if the ignition
switch is turned from ON to ACC or OFF during check
mode, the DTCs and freezed frame data will be erased.
DI–3 to confirm the details of the DTCs.
Author : Date :
241