Toyota Camry Manual page 1361

DI–334
INSPECTION PROCEDURE
HINT:
Read freeze frame data using TOYOTA hand–held tester or OBD II scan tool. Because freeze frame records
the engine conditions when the malfunction is detected, when troubleshooting it is useful for determining
whether the vehicle was running or stopped, the engine warmed up or not, the air–fuel ratio lean or rich, etc.
at the time of the malfunction.
1 Check operation of speedometer.
CHECK:
Drive the vehicle and check if the operation of the speedometer in the combination meter is normal.
HINT:
The vehicle speed sensor is operating normally if the speedmeter display is normal.
OK
2 Check for short in harness and connector between terminal SPD of ECM and
body ground (See page IN–31).
OK
DIAGNOSTICS –
NG
PREPARATION:
(a) Remove the glove compartment (See page SF–73).
(b) Disconnect the E8 connector of ECM.
CHECK:
Check continuity between terminal SPD of ECM and body
ground.
E8
OK:
SPD
No continuity (1 MΩ or higher)
A02030
NG
ENGINE (1MZ–FE)
Check speedmeter circuit.
Repair or replace harness or connector.
Author : Date :
569