Toyota Camry Manual page 1368

CONFIRMATION DRIVING PATTERN
Vehicle Speed
60 ∼ 120 km/h
(38 ∼ 75 mph)
Idling
IG SW OFF
(a) Connect the TOYOTA hand–held tester to the DLC3.
(b) Switch the TOYOTA hand–held tester from normal mode to check mode (See page DI–197).
(c) Start the engine and warm it up with all accessory switches OFF.
Drive the vehicle at 60 ∼ 120 km/h (38 ∼ 75 mph) and engine speed at 1,600 ∼ 3,200 rpm for 3 ∼ 5 min.
(d)
HINT:
If a malfunction exists, the MIL will light up during step (4).
NOTICE:
If the conditions in this test are not strictly followed, detection of the malfunction will not be possible.
If you do not have a TOYOTA hand–held tester, turn the ignition switch OFF after performing steps
(3) and (4), then perform steps (3) and (4) again.
INSPECTION PROCEDURE
HINT:
D
If DTC P1130 is displayed, check Bank 1 Sensor 1 circuit.
D
If DTC P1150 is displayed, check Bank 2 Sensor 1 circuit.
D
Read frame freeze data using TOYOTA hand–held tester or OBD II scan tool. Because freeze frame
records the engine conditions when the malfunction is detected, when troubleshooting it is useful for
determining whether the vehicle was running or stopped, the engine warmed up or not, the air–fuel
ratio lean or rich, etc. at the time of the malfunction.
1 Are there any other codes (besides DTC P1130, P1150) being output?
NO
DIAGNOSTICS
(3)
(1)(2)
YES
– ENGINE (1MZ–FE)
(4)
3 ∼ 5 min.
Go to relevant DTC chart.
Author :
Time
Date :
DI–341
A00364
576