Toyota Camry Manual page 1453

DI–426
INSPECTION PROCEDURE
1 Read PNP, REVERSE, 2ND and LOW signals.
ON
w/ Engine Immobiliser System
(+)
(–)
w/o Engine Immobiliser System
(–) (+)
BE3840
Q08479
D00043
NG
DIAGNOSTICS
When using TOYOTA hand–held tester:
PREPARATION:
(a)
(b)
(c)
CHECK:
Shift the shift lever into the P, R, N, 2 and L positions, and read
the PNP, REVERSE, 2ND and LOW signals on the TOYOTA
hand–held tester.
OK:
When not using TOYOTA hand–held tester:
PREPARATION:
Turn the ignition switch ON.
CHECK:
Measure voltage between terminals NSW, 2, L and R of ECM
and body ground when the shift lever is shifted in the following
positions.
L
OK:
NSW 2
R
R
L
2
NSW
HINT:
The voltage will drop slightly due to lighting up of the back up
D00994
light.
– AUTOMATIC TRANSAXLE (A140E)
Remove the DLC3 cover.
Connect a TOYOTA hand–held tester to the DLC3.
Turn the ignition switch ON and TOYOTA hand–held tes-
ter main switch ON.
Shift position
2
L
R
P, N
NSW–Body
Position
ground
P, N
0 V
9 ∼ 14 V*
R
9 ∼ 14 V
D
9 ∼ 14 V
2
9 ∼ 14 V
L
OK Proceed to next circuit inspection shown on
matrix chart (See page DI–405).
Author :
Signal
2ND OFF
LOW OFF
REVERSE OFF
PNP OFF
R–Body 2–Body
ground ground
0 V
0 V
9 ∼ 14 V*
0 V
0 V
0 V
9 ∼ 14 V
0 V
0 V 0 V
Date :
ON
ON
ON
ON
L–Body
ground
0 V
0 V
0 V
0 V
9 ∼ 14 V
661