Operation As A Satellite Pabx; External Line Connection; Second Code For External Access - Siemens HiPath 1100 Series Programming Manual

Step by Step
1
... or
0 9 0 0

Operation as a Satellite PABX

External Line Connection

This feature determines if an external analog line
connected to one of the HiPath 1100 systems is also
connected to a local carrier or another PABX.
Required: Programming Mode must be active (*95
31994).
Enter the code for programming.
3 3
... Enter the number for the group of external lines (e.g., 0,
890).
or Enter the code for the type of connection:
2
= Connection to a local carrier (default)
1
= Connection to another PABX system
2
Press this key.
#
Initial state for Programming Mode.

Second Code for External Access

This setting specifies the code used by the main PABX
for accessing external lines. This code is used to check
if there is a dial tone at an external line and to generate
a pause while dialing, redialing or using the speed
dialing feature.
The default setting for the second code is "0."
Required: Programming Mode must be active (*95
31994).
Enter the code for programming.
3 4
Enter the external access code for the main PABX (one
...
9 9
or two digits) and wait for a confirmation tone:
...
0
it
0 0
digits
When a group of external lines is programmed as
a Satellite PABX, a false dial tone is not generat-
ed.
= Second external access code, one dig-
9
... = Second external access code, two
9 9
Programming an External Line
39