Perkins 1106D Disassembly And Assembly page 97

SENR9983
d. Remove the engine oil pan. Refer to Disassembly
and Assembly Manual, "Engine Oil Pan -
Remove".
e. If the engine has an accessory drive, remove
the accessory drive. Refer to Disassembly and
Assembly Manual, "Accessory Drive - Remove
and Install".
f. Remove the timing gears. Refer to Disassembly
and Assembly Manual, "Gear Group (Front) -
Remove and Install".
g. Remove the fuel injection pump. Refer to
Disassembly and Assembly Manual, "Fuel
Injection Pump - Remove".
NOTICE
Keep all parts clean from contaminants.
Contaminants may cause rapid wear and shortened
component life.
NOTICE
Care must be taken to ensure that fluids are contained
during performance of inspection, maintenance, test-
ing, adjusting and repair of the product. Be prepared to
collect the fluid with suitable containers before open-
ing any compartment or disassembling any compo-
nent containing fluids.
Dispose of all fluids according to local regulations and
mandates.
1. Drain the coolant into a suitable container for
storage or disposal. Refer to Operation and
Maintenance Manual, "Cooling System Coolant -
Drain" for the correct procedure.
Illustration 190
2. Remove the two setscrews (1) that secure the
bypass tube (2) to the front housing (3). Remove
the bypass tube (2) from the cylinder head.
Remove the O-rings (4) and (5) from the bypass
tube (2). Discard the O-rings.
Illustration 191
3. Remove the setscrews (7), (8) and (9) from the
front housing (3).
Note: The setscrews are three different lengths. Note
the positions of the different setscrews.
4. Remove the front housing (3) from the cylinder
block.
5. Remove the joint (6). Discard the joint.
Illustration 192
6. Remove the thrust washer (10) from the cylinder
block.
g01180542
Disassembly and Assembly Section
97
g01176043
g01175068