Perkins 1106D Disassembly And Assembly page 126

126
Disassembly and Assembly Section
Illustration 259
Alignment of timing marks
5. Mark the gears (1) and (8) in order to show
alignment. Refer to Illustration 259.
Note: Identification will ensure that the gears can be
installed in the original alignment.
Illustration 260
6. Remove Tooling (B). Remove the setscrew (3)
and the washer (2) from camshaft gear (1).
7. Remove the camshaft gear (1) from the camshaft.
Note: If the camshaft gear is a tight fit on the nose
of the camshaft, use a prybar in order to remove the
camshaft gear.
8. If necessary, remove the key (not shown) from the
nose of the camshaft.
Installation Procedure
Table 58
Tool
B
C
Keep all parts clean from contaminants.
Contaminants may cause rapid wear and shortened
g01196847
component life.
1. Ensure that number one piston is at top dead
center on the compression stroke. Refer to the
Testing and Adjusting Manual, "Finding Top Center
for No. 1 Piston".
Illustration 261
2. Ensure that Tooling (C) is installed in hole (Y) in
the cylinder block. Use Tooling (C) in order to
lock the crankshaft in the correct position. Refer
to Testing and Adjusting Manual, "Finding Top
Centre Position for No.1 Piston".
g01196850
3. Ensure that the camshaft gear and the key are
clean and free from wear or damage.
4. If necessary, install the key into the nose of the
camshaft.
Note: Ensure that the key is squarely seated.
Illustration 262
Required Tools
Part
Part Name
Number
27610212
Camshaft Timing Pin
27610286
Crankshaft Timing Pin
NOTICE
SENR9983
Qty
1
1
g01195325
g01196831