Perkins 1106D Disassembly And Assembly page 17

SENR9983
Illustration 23
Typical example
Illustration 24
Typical example
6. Place a suitable container below the fuel injection
pump (1) in order to catch any fuel that might be
spilled.
Note: Clean up any spillage of fuel immediately.
7. Disconnect the plastic tube assembly (2) from the
fuel injection pump (1).
8. Disconnect the engine wiring harness (7) from the
solenoid (3) of the fuel injection pump. Disconnect
the engine wiring harness (7) from the position
sensor (4) for the fuel injection pump.
Note: The engine wiring harness should be
positioned in order to avoid an obstruction to the fuel
injection pump.
9. Remove the plastic tube assembly (11) from the
fuel transfer pump (8).
10. Disconnect the plastic tube assembly (10) from
the outlet of the fuel transfer pump (8).
11. Disconnect the plastic tube assembly (5) from the
fuel injection pump (1).
12. Remove the tube assembly (12) for the fuel return
g01173307
from the fuel transfer pump and the cylinder head.
Note: Disconnect the tube assembly at the fuel
transfer pump first in order to drain the fuel from the
cylinder head.
13. Remove the tube assembly (9) for the engine oil
supply to the fuel injection pump (1).
14. Plug or cap all open ports and tube assemblies
immediately with new plugs or caps.
15. Remove the fuel injection line (6) that connects
the fuel injection pump to the fuel manifold. Refer
to Disassembly and Assembly Manual, "Fuel
Injection Lines - Remove". Use Tooling (D) in
order to plug the open ports in the fuel injection
pump and in the fuel manifold. Discard the fuel
injection line.
g01173310
Disassembly and Assembly Section
17