Perkins 1106D Disassembly And Assembly page 80

80
Disassembly and Assembly Section
Illustration 147
Engine with an aluminum oil pan
Illustration 148
Engine with cast iron oil pan
4. Clean the rear face of the cylinder block. If
necessary, install the two dowels (5) to the cylinder
block.
5. Install the Tooling (A) to the cylinder block.
6. Align a new joint (7) with Tooling (A). Install the
joint to the cylinder block.
7. If the engine has an aluminum oil pan, install the
dust seal (6).
If the engine has a cast iron oil pan, apply a bead
of Tooling (B) to positions (X).
8. Install a suitable lifting device to the flywheel
housing. The flywheel housing can weigh 32 kg
(70.5 lb).
g01215184
Illustration 149
9. Use the lifting device to align the flywheel housing
(1) with Tooling (A). Install the flywheel housing to
the cylinder block.
10. Install the two M16 setscrews (2), two M12
setscrews (4) and two M10 setscrews (3).
11. Remove Tooling (A). Install the remaining two
M10 setscrews (3).
12. Tighten the M16 setscrews (2) to a torque of
190 N·m (140 lb ft).
Tighten the M12 setscrews (4) to a torque of
115 N·m (85 lb ft).
g01215185
Tighten the M10 setscrews (3) to a torque of
63 N·m (46 lb ft).
13. Check the alignment of the flywheel housing (1)
with the crankshaft. Refer to Testing and Adjusting
Manual, "Flywheel Housing - Inspect".
End By:
a. Install the flywheel. Refer to Disassembly and
Assembly Manual, "Flywheel - Install".
SENR9983
g01202953