Perkins 1106D Disassembly And Assembly page 57

SENR9983
Note: Clean up any spillage immediately.
Illustration 98
Typical example of an engine oil cooler with a blanking plate
Illustration 99
Typical example of an engine oil cooler with a high mounted filter
base
3. If the engine has a left hand side oil filter, remove
the oil filter base. Refer to Disassembly and
Assembly Manual, "Oil Filter Base - Remove and
Install".
If the engine has a right hand side oil filter, follow
Steps 3.a through 3.c in order to remove the
blanking plate (12). Refer to Illustration 98.
a. Remove the four setscrews (11).
b. Remove the blanking plate (12).
c. Remove the joint (not shown). Discard the joint.
4. Make temporary identification marks on the plastic
tube assemblies (3) in order to show the correct
position of the tube assemblies.
5. Remove the plastic tube assemblies (3). Plug all
plastic tube assemblies with new plugs. Cap all
open ports with new caps.
6. Follow Steps 6.a through 6.d in order to disconnect
the engine wiring harness (4).
a. Disconnect the engine wiring harness (4) from
the position sensor (2) for the fuel injection
pump.
b. Disconnect the engine wiring harness (4) from
the solenoid (1) for the fuel injection pump.
c. Disconnect the engine wiring harness (4) from
the oil pressure sensor (13).
g01181109
d. Cut the cable ties that secure the engine wiring
harness (4) to the assembly of the oil cooler (6).
Position the harness away from the assembly
of the oil cooler.
7. Remove the tube assembly (9) for the fuel return
from the cylinder head (not shown) and from the
transfer pump (8). Plug the tube assembly with
new plugs. Cap all open ports with new caps.
g01204901
Illustration 100
Typical example of engine oil cooler with a blanking plate or with a
low mounted filter base
8. If necessary, loosen the two setscrews (15).
Remove the setscrews (7) and remove the
brackets (5) and (10) for the tube assemblies.
Remove the assembly of the oil cooler (6) from
the cylinder block.
Note: The setscrews are different lengths. Note the
position of the different setscrews. Note the location
and the orientation of the brackets for the tube
assemblies.
Disassembly and Assembly Section
57
g01205285