Perkins 1106D Disassembly And Assembly page 9

SENR9983
Illustration 7
Typical example
3. Remove the plastic tube assembly (2) from the
fuel transfer pump (1).
4. Disconnect the plastic tube assembly (3) from the
outlet of the fuel transfer pump (1).
5. Remove the connector (4) from the fuel transfer
pump (1). Remove the O-ring seal (not shown)
from the connector (4). Discard the O-ring seal.
If necessary, remove the connector (7) from the
fuel transfer pump (1). Remove the O-ring seal
(not shown) from the connector (7). Discard the
O-ring seal.
6. Remove the tube assembly (6) for the fuel return
from the fuel transfer pump and the cylinder head.
Note: Disconnect the tube assembly at the fuel
transfer pump first in order to drain the fuel from the
cylinder head.
7. Remove the tube assembly (5) for the engine oil
supply from the fuel injection pump (8).
8. Plug or cap all open ports and tube assemblies
immediately with new plugs or caps.
9. Use an allen wrench with a ball end in order to
remove the five allen head screws (9) that secure
the fuel transfer pump to the fuel injection pump
(8).
Illustration 8
10. Remove fuel transfer pump (1) from the fuel
injection pump (8).
Note: Do not remove the dowels (10) from the fuel
injection pump.
g01162545
Illustration 9
11. Remove the O-ring seal (11) from the fuel transfer
pump (1). Discard the O-ring seal.
Disassembly and Assembly Section
9
g01162543
g01162544