Perkins 1106D Disassembly And Assembly page 106

106
Disassembly and Assembly Section
10. Install the cover (1) to the breather body (4).
Note: Ensure that the outlet of the cover is in the
correct position in order to align with the hose (12)
for the breather.
Illustration 209
11. Install the two clamps (11) to the hose (12).
12. Connect the hose (12) to the cover (1) and to the
tube (13). Tighten the clamps.
Installation Procedure (Filtered
Breather)
Table 50
Required Tools
Part
Tool
Number
-
A Breather Tool
NOTICE
Keep all parts clean from contaminants.
Contaminants may cause rapid wear and shortened
component life.
g01200791
Part Description Qty
1
Illustration 210
Breather tool
1. To install the breather body, Tooling (A) must be
used. The tool should be fabricated from 3.1 mm
(1/8 inch) steel stock. The dimensions for the tool
are given in Illustration 207. All dimensions are
shown in millimeters.
SENR9983
g01206039