Perkins 1106D Disassembly And Assembly page 124

124
Disassembly and Assembly Section
4. If necessary, remove the key (4) from the camshaft
(3).
Installation Procedure
NOTICE
Keep all parts clean from contaminants.
Contaminants may cause rapid wear and shortened
component life.
1. Clean the camshaft and the thrust washer. Inspect
the camshaft and the thrust washer for wear
and for damage. Refer to Specifications Manual,
"Camshaft" for more information. Replace any
worn components or any damaged components.
2. Clean the camshaft bearing in the cylinder
block. Inspect the camshaft bearing for wear
and for damage. Refer to Specifications Manual,
"Camshaft Bearings" for more information. If
necessary, replace the camshaft bearing. Refer to
Disassembly and Assembly Manual, "Camshaft
Bearing - Remove and Install".
NOTICE
It is strongly recommended that all lifters should be
replaced when a new camshaft is installed.
3. Inspect the lifters for wear and for damage.
Refer to Specifications Manual, "Lifter Group"
for more information. Replace any worn lifters or
any damaged lifters. Refer to Disassembly and
Assembly Manual, "Lifter Group - Remove and
install".
Illustration 254
4. If necessary, install a new key (4) into the
camshaft (3).
5. Lubricate the bearing surfaces of the camshaft (3)
and lubricate the lobes of the camshaft with clean
engine oil.
Do not damage the lobes or the bearings when the
camshaft is removed or installed.
6. Carefully install the camshaft (3) into the cylinder
block.
Illustration 255
Typical example
7. Lubricate the thrust washer with clean engine oil.
Align the slot (X) in the thrust washer (1) with the
dowel (2) in the cylinder block. Install the thrust
washer (1) into the recess in the cylinder block.
Note: The thrust washer can have one or two slots
(X).
End By:
a. Install the front housing. Refer to Disassembly and
Assembly Manual, "Housing (Front) - Install".
b. Install the rockershaft and pushrods. Refer to
Disassembly and Assembly Manual, "Rocker shaft
and Pushrod - Install".
g01167301
SENR9983
NOTICE
g01167327