Perkins 1106D Disassembly And Assembly page 128

128
Disassembly and Assembly Section
Start By:
a. Remove the engine oil pump. Refer to
Disassembly and Assembly Manual, "Engine Oil
Pump - Remove".
b. Remove the camshaft. Refer to Disassembly
and Assembly Manual, "Camshaft - Remove and
Install".
NOTICE
Keep all parts clean from contaminants.
Contaminants may cause rapid wear and shortened
component life.
Illustration 266
1. Inspect the camshaft bearing (1). Refer to
Specifications Manual, "Camshaft Bearings" for
more information.
2. If the camshaft bearing (1) is worn or damaged
use Tooling (A) in order to remove the camshaft
bearing from the cylinder block.
Note: Remove the camshaft bearing from the front of
the cylinder block.
Installation Procedure
NOTICE
Keep all parts clean from contaminants.
Contaminants may cause rapid wear and shortened
component life.
1. Clean the bearing housing in the cylinder block.
Ensure that the oil hole in the bearing housing is
free from debris.
Illustration 267
2. Lubricate the bearing housing in the cylinder block
with clean engine oil.
3. Accurately align the large oil hole (X) in camshaft
bearing (1) with the oil hole in the cylinder block.
Note: The groove (Y) in the camshaft bearing must
be to the top of the cylinder block.
4. Use Tooling (A) in order to install the camshaft
bearing (1) into the cylinder block. Install the
g01178163
camshaft bearing so that the front edge of the
bearing is flush with the face of the recess in the
cylinder block.
Note: Ensure that the oil holes are correctly aligned.
If the oil is not correctly aligned, the camshaft bearing
should be removed.
End By:
a. Install the camshaft. Refer to Disassembly and
Assembly Manual, "Camshaft - Remove and
Install".
SENR9983
g01167595