Perkins 1106D Disassembly And Assembly page 135

SENR9983
Illustration 279
Typical example
11. If necessary, follow Steps 11.a through 11.c in
order to install the assembly of the dipstick tube.
a. Install a new seal (3) to the tube assembly (2).
b. Apply Tooling (D) to the nut (1). Install the tube
assembly to the engine oil pan.
Note: Ensure that the orientation of the tube
assembly is correct.
c. Tighten the nut (1) to a torque of 18 N·m
(13 lb ft). Install the dipstick (not shown).
12. Fill the engine oil pan to the correct level. Refer
to Operation and Maintenance Manual, "Oil Filter
Change" for the procedure.
End By:
a. If necessary, install the flywheel housing. Refer to
Disassembly and Assembly Manual, "Flywheel
Housing - Remove and Install".
Installation Procedure (Cast Iron
Oil Pan)
Table 63
Required Tools
Part
Tool Number
-
A T40 Torx Socket
POWERPART
21826038
C
Silicon Rubber Sealant
POWERPART
21820117
D
Threadlock and Nutlock
-
E Straight Edge
Note: In order to install a cast iron oil pan, the engine
must be removed from the application.
g01212465
Part Description Qty
1
-
-
1
Disassembly and Assembly Section
NOTICE
Keep all parts clean from contaminants.
Contaminants may cause rapid wear and shortened
component life.
NOTICE
Care must be taken to ensure that fluids are contained
during performance of inspection, maintenance, test-
ing, adjusting and repair of the product. Be prepared to
collect the fluid with suitable containers before open-
ing any compartment or disassembling any compo-
nent containing fluids.
Dispose of all fluids according to local regulations and
mandates.
1. Ensure that the joint face of the cylinder block is
clean and free from damage. Inspect the studs
in the cylinder block (not show) for damage. If
necessary, replace the studs.
2. Ensure that the engine oil pan is clean and free
from damage.
Illustration 280
Typical example
3. Apply a bead of Tooling (C) to positions (Y).
135
g01215533